Archive for admin

What do you do when a 60A circuit needs its positive and negative leads to travel through two different points in an enclosure? A fixed two-pole housing forces both leads down the same path. That is not always how a real harness is laid out. The MR60 connector solves this at the higher current end. […]

Does every 30A connection need its positive and negative leads locked into one fixed housing? Not always. Some harness layouts route the two poles separately. They may need more spacing or greater flexibility. They may also pass through different points in an enclosure. The MR30 connector suits this type of routing. It uses a round […]

Can a round connector really carry the same current as a flat rectangular one without a bulkier housing? At the 60A mark, this stops being a minor design detail and starts shaping how cleanly a harness routes through a tight enclosure. The MT60 connector is the higher-current step up from MT30, a round bullet-style connector […]

Does the shape of a connector’s pin actually matter when the current rating remains the same? For assembly teams working with tight enclosures or round-profile housings, it matters more than most spec sheets suggest. The MT30 connector is a compact, round bullet-style connector rated for roughly 30A continuous current. It suits applications where fit and […]

What connector do you reach for when a circuit is pulling well past 60A and failure isn’t an option? At that current level, a standard XT60 starts running hot, and a loose or undersized joint can become a genuine safety risk rather than just an inconvenience. This is where the XT90 connector comes in, the […]

What happens to a connector rated for 30A the moment your circuit starts pulling 45? It heats up, the housing softens, and the joint you trusted starts to fail quietly, long before anything trips. This is the exact gap the XT60 connector is built to close. It sits in the middle of the XT family, […]

How much current does your battery circuit need to carry? Choosing the wrong connector can create problems. You may oversize the build and add unnecessary cost. You may also risk overheating a joint that cannot handle the load. This is where the XT30 connector earns its place. It is the smallest member of the XT […]

In PCB-based electrical assemblies, PCB Mounting Connectors are more than a matter of appearance. The way a connector sits on a printed circuit board can influence cable routing, available space, enclosure design and the overall layout of the assembly. Two commonly considered configurations are Straight (ST) Connectors and Right-Angle (R/A) Connectors. Both are designed for […]